While some choose to discover nothing, inspire no one and dream small we here at B&T have taken a different path. The Patented Atlas Bipod lines brought new and novel features to the bipod that had not been seen before (including built in Pan and Cant and the novel 45 degree leg positioning). We own these ideas and encourage our customers to Accept No Substitutions.

Please select from the icons below to see which best fits your application.

BT01 PSR Atlas Bipod 5-H

Atlas in Action

Un-assembly Service for Applying a New Finish

Anyone that wishes to apply a new finish to an Atlas bipod needs to be aware of the following:

Anyone planning on applying coatings to the Atlas Bipod that require heat or disassembly are respectfully asked to send their bipod to B&T Ind. L.L.C. where we will disassemble it and return all anodized parts for coating to the customer. Once the coating is applied the finished parts are returned to B&T and we will reassemble them to our specifications and return the assembled bipod back to the customer. We will provide this service for 54.95 (which includes; Processing the initial request, Pulling a bipod assembly person off line to disassemble your bipod, Packaging the parts to ship, Packaging and filing the parts for that bipod we keep, Shipping parts to finisher, Receiving the finished parts back into our system, Pulling the non-finished parts for assembly, Pulling a bipod assembly person off line to assemble the bipod, Packaging and shipping it to the customer.) B&T Industries L.L.C. will not be responsible for the finish.

Anyone that disassembles their bipod, lose or break parts in an attempt to disassemble or cannot reassemble the Atlas Bipod will be charged 75.95 for this service.

Anyone choosing not to use this service does so at their own risk and liability voiding the bipods warranty.

B&T Industries L.L.C. does not sell or ship parts.

Please note; the Atlas bipods leg’s extension function are close tolerance so the amount of finish applied may affect this functionality so a light coating on the inner leg grooves and around the ball holes on the outer leg is suggested. If the coating negatively impacts this function, we will remove the minimal amount of finish material in these areas to allow proper function.