We strive to maintain our inventory to meet the demand for our products and normally ship within two business days, however at times we get large orders that require all of our available inventory resulting in a back-order status. If you would like to inquire about availability please call and we'll provide current inventory status. We apologize for this inconvenience and thank you for your business and patience, neither of which we take for granted.
B&T Industries L.L.C. is proud to introduce the Bitter & Twisted Mortar model display. The Mortar model is constructed from turned and stamped Stainless Steel and quarter sawn American White Oak.
The Barrel is turned 300 series Stainless Steel with bored trunnion pockets, the trunnions are pressed into the pockets then welded in place. The trunnions rest on a pair of stainless steel bearing plates in the Mortar model Base and is retained by a pair of Stainless Steel Top Straps via two ¼-20 Stainless Steel Button Head cap screws per strap passing through the straps then into the Side and thread into the Stainless Steel handle found on each Side of the Base. Strength is obtained and secured by steel on steel threads.
The Mortar model Base is quarter sawn American White Oak with the two Sides having a strengthening element bonding them to the Base Bottom. These Joints are then reinforced with two ¼-20 Stainless Steel Button Head cap screws per side that in assembly pass through the Base Side, into the Base Bottom and terminate after threading into vertically located Bar Nuts having one end threaded for the standard rubber foot.
This Mortar model has a bore of 1.70” in diameter and is 6 inches deep. The fuse hole measures .140 in diameter and is blind, meaning it does not penetrate into the models Powder Chamber and incapable of being fired. The Mortar model weighs over 22 pounds.
The Mortar model display will be shipped with a 1000 denier Cordura nylon bag having a Kydex insert in the bottom for strength, three separate pockets with flaps are found inside along with a set of Velcro straps that pass through the Mortar model display handles to secure it into the case, two wrap around carry handles complete the custom case. Color is Khaki, it is American made by CSM Gear.
PLEASE NOTE- THE MORTAR MODEL IS FOR DISPLAY PURPOSES ONLY! ANY ATTEMPT TO ALTER THE MORTAR MODEL TO PERMIT ANY USEAGE OTHER THAN ITS INTENDED DESIGN WILL VOID ALL WARRANTIES, EXPRESS OR IMPLIED, AND COULD RESULT IN PROPERTY DAMAGE, INJURY, OR DEATH. B&T INDUSTRIES L.L.C. ASSUMES NO RESPONSIBILITY FOR ANY MISUSE OF THIS PRODUCT.